My first 1/2a Reay to go!
09-26-2008, 07:17 AM
#26
RE: My first 1/2a Reay to go!
The race is in Burlington, NC, on October 4.
Any airframe with an .049 reed motor hence "reedie race".
Again any airfram with max engine size of .074 for unlimited.
I suspect there will be a Sure Shark in the crowd.[8D]
Always a good time.
Any airframe with an .049 reed motor hence "reedie race".
Again any airfram with max engine size of .074 for unlimited.
I suspect there will be a Sure Shark in the crowd.[8D]
Always a good time.
09-26-2008, 07:51 AM
#27
Join Date: Feb 2007
Location: Stockton Springs, ME
Posts: 1,654
Likes: 0
Received 3 Likes
on
3 Posts
RE: My first 1/2a Reay to go!
ORIGINAL: iflyg450
No not made from a box of tin foil, BUT WHAT A GREAT IDEA!!! Where in CT do you fly? My father flies at quaker farms in waterbury. I grew up flying with him at Sherwood Island in Norwalk.
No not made from a box of tin foil, BUT WHAT A GREAT IDEA!!! Where in CT do you fly? My father flies at quaker farms in waterbury. I grew up flying with him at Sherwood Island in Norwalk.
09-26-2008, 01:22 PM
#28
Senior Member
Join Date: Feb 2004
Location: Wasilla,
AK
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
RE: My first 1/2a Reay to go!
Howdie gents. I was worried that Rattle would be hard to see in the air but found that the red and yellow really stood out once it was in the air. I used the micro light on Tictock and liked the way that it went on. It goes around corners real nice. The thing I found is that all the seams are a darker shade and its hard to lay up a different color on top with out it looking like it was drawn on with a crayon. It changes the tone of the top sheet . I would think about a pinstripe around the out side of the plane, this would give it an outline that will define the plane in the air. hkbii.
