1/24 losi
Got a li-po for a 1/24 losi sct. The truck runs fine on nimh but won't work at all on li-po. Voltage on li-po is 8.4. Servo works but the motor won't. Anybody know what might be wrong?
|
RE: 1/24 losi
Is should work... Did on mine..... Something's not right. What ESC and motor? Did u reset the ESC? Or mess with the trim knobs?
|
RE: 1/24 losi
Figured it out. Losi sent a replacement esc.
|
RE: 1/24 losi
So, the stock electronics can handle LiPo voltage? Are the 1/36 cars the same way?
|
RE: 1/24 losi
As for 1/36. I can only assume. might be worth checking the losi web site
be carefull, when running my SCT on a lipo the motor got so hot the pinion melted off. easy wix with metal gears... But I highly recomend the brushless kits. im running on now. |
RE: 1/24 losi
If you bought one of the new brushless 1/24th models there have been many reports that some have problems running 2s lipo with their ESC/receiver. Some have had luck running the pack down a little before running it in the car but it's best to contact Horizon or Losi to get a replacement.
|
RE: 1/24 losi
It is the brushless. The esc was not allowing the li-po to work due to the voltage of the pack. The esc was detecting a 3s and I only had a 2s installed. If I ran the surface charge off the pack it worked fine. Horizon sent me a new esc but I haven't used it yet.
|
All times are GMT -8. The time now is 11:57 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.