Sniper Update?
#3
Senior Member
Join Date: May 2003
Location: Concord, NC,
Posts: 2,494
Likes: 0
Received 0 Likes
on
0 Posts
RE: Sniper Update?
Well it's one little thing after another[] I am wanting/going to change the backplate design from a screw in back to a bolt on back. Being that it's a rear disk intake the anodizing on the case is enough to change where the backplate comes to a stop and that of course changes the timing. Plus I think the mounting beams need to be widened alittle too. So it's back to the drawing board and then I have to get the parts made again. So it's a good ways off yet it looks like before I can honestly say "Sniper DR .020's on Sale now". Thanks for asking about it guys!
Later,
Tim
Later,
Tim