pusher prop for sure start .049
does any one make a pusher prop for an .049
|
RE: pusher prop for sure start .049
Cox and Grish did make a few reverse pitch props , but for a reedie just put the prop on backwards and run the engine clockwise.
|
RE: pusher prop for sure start .049
Just turn your prop around - the Sure Start runs equally well in both directions, but you may get some galling or increased wear on the nose of the case in a pusher configuration. Add a couple of drops of fuel or light oil to the juncture between the case nose and thrust washer before starting - there may be enough blowby to keep it lubed while running. If you're seeing a lot of dark oil buildup behind the thrust washer, you may need to add a thin steel, brass or PTFE washer. If it's too tight, you can always file the nose slightly to get enough clearance then polish with some 400 grit with oil on glass.
andrew |
RE: pusher prop for sure start .049
Some of the Sure Starts have brass drive plates. These were for pusher use.
|
RE: pusher prop for sure start .049
thanks for the help i have some with brass drive plate
|
All times are GMT -8. The time now is 03:45 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.