RE: RCM Plans Corkscrew
I joined the wing panels in a more traditional manner than that called for on the plans with center ribs epoxied together. The center section was sheeted with 1/16" balsa. The aileron servo hole was cut out so that the servo could stand upright instead of laying on it's side as on the drawings. The torque rods were bent with 5 degrees of offset to provide aileron differential(more up than down) per the plans. The trailing edge pieces were channeled so that the torque rod sleeves would fit flush for mounting.
GarySS, I would love to see more of your Corkscrew pics and updates.