View Single Post
Old 12-10-2011, 01:36 PM
  #23  
tande
Senior Member
My Feedback: (48)
 
Join Date: Dec 2003
Location: Millington, MI
Posts: 990
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Fuel Barb Soldering Help Please!

Again FWIW.....For anyone who might be interested in trying the "Fiji" water bottle fuel tank, the following IS a worthwhile test;....With a fresh non/opened bottle of "Fiji" water, use a felt/tip pen to make an "Indexing" mark across the cap & bottle where the two meet....Now remove the cap & the "Tamper/Proof" ring....Reinstall the cap & line up the marks to learn just how tight the cap was originally installed.....Might surprise ya! ....So, don't over/tighten when you build your new fuel tank....Just say'in....
tande is offline  
Reply With Quote