RE: Help!! A-10 brushless EDF motor issues
It is likely that the ESC's need to be programmed to your x-meter's throttle curve....no need to disconnect one of them, as both can be set at the same time.
Power to plane/esc's/motors OFF
Move T stick full up, THEN, turn ON x-mitter.
Now, power up the A-10....you should hear a tone or two from each motor.....now, move T stick to full down.
Remove power from A-10, then turn x-mitter off
Power up x-mitter, then A-10.....EDF's should respond equally.
If that does not solve the issue, further programming of ESC's may be necessary....but, without knowing brand of ESC's, I can't help any further.