ORIGINAL: kane
Airtech,
There is a thread on a different site that may have some insight. It seems that some kits have this issue and others do not.
Some cures include:
1. Squeeze the cheeks together when sliding the canopy in, this creates a small gap between the top of the cowl and the former.
2. Sand the top of the former causing the issue. CARE should be taken that too much is not removed.
Are you able to get the canopy on at all? Or is just a pain?
Dan Kane
I did found out squeezing the cheeks helps a little but it's still a pain to instal. Gluing a couple of 1/64" veneer pieces to the top sides of the former helps some.