The canopy on the plane I got from Troy Built Models, and I have a spare that was made by Park Flyer Plastics, using the ESM canopy as a guide for a plug. I'll probably have to put the spare on someday, as the ESM one is so flimsy all I have to do is look at it wrong and it cracks. It's not absolutely necessary to have a molded canopy, tho, as the plans show how to make the panels from sheet plastic.
The cowl I built from the plans. Jim provided a drawing of the cowl sections on the plans, so it wasn't too hard to do. I just divided them in half on the centerline (top and bottom), took a quarter inch off at the centerline, and built two halves on 1/8 crutches, then joined them later.
Last edited by Mustang Fever; 02-10-2015 at 05:47 AM.