RCU Forums - View Single Post - Loaded Dice II Build Thread
Thread
:
Loaded Dice II Build Thread
View Single Post
04-28-2015, 05:04 PM
#
58
waynek
Member
Join Date: Dec 2004
Location: Ottawa, ON CANADA
Posts: 72
Likes: 0
Received 0 Likes on 0 Posts
Needed to fabricate something to melt the servo cutout in the wing. One for each side. Seemed to turn out OK. I've seen guys using the trigger-operated soldering guns (like my dad had when I was a kid) for this to very good effect also.
W
Attached Thumbnails
Reply
Like
waynek
View Public Profile
Send a private message to waynek
Find More Posts by waynek
View iTrader Profile