I replaced the gyro with a G210 and the tail servo with a 450 servo. I set up the head from the swash to the blades as per a youtube video from Horizon. I had it hovering for about 5 minutes, then it started losing the tail authority.
It rotated CCW, I gave it full right rudder to bring the tail CW with no response. The drift was slow enough by the time I cut power and dropped it, it was nose in. At this point, not sure what happened. I did notice that each time I gave rudder input during hover, the gyro light would blink. One good note, the tail rotor did not have any more chips on the trailing edge, so far.
Last edited by swashmixtexas; 10-05-2015 at 07:49 PM.