RCU Forums - View Single Post - Stihl MS660 big bore conversion.
Thread
:
Stihl MS660 big bore conversion.
View Single Post
10-18-2015, 12:23 PM
#
48
Jim.Thompson
Join Date: Sep 2015
Location: Bellingen NSW Australia
Posts: 332
Likes: 0
Received 0 Likes on 0 Posts
Thanks again Zagnut.
I will look at the HobbyKing offering. However, I just might be able to get an engineer pal to make me up a drill guide. Unless of course, I figure out how to do it without a mill.
Reply
Like
Jim.Thompson
View Public Profile
Send a private message to Jim.Thompson
Find More Posts by Jim.Thompson
View iTrader Profile