Old 10-26-2015, 02:21 PM
  #27  
guapoman2000
 
guapoman2000's Avatar
 
Join Date: Nov 2003
Location: Orlando, FL
Posts: 1,647
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default

Guys,

I had an opportunity to measure the UP Elevator Deflection on each Elevator Halves and was horrified to witness that the LEFT Elevator Half has 1/2 inch more than the Right Elevator half.

This certainly caused the model to ROLL to the Left on each LOOP attempt and certainly caused a stall way UP high and subsequent spin.

I will try the least expensive and less intrusive solution to the issue by disconnecting the clevis at the Right and see about increasing the RIGHT Elevator Travel while decreasing the LEFT some as well.







guapoman2000 is offline  
Reply With Quote