RCU Forums - View Single Post - Assult Sherman, Jumbo build
Thread
:
Assult Sherman, Jumbo build
View Single Post
12-10-2015, 10:51 PM
#
20
RichJohnson
Join Date: Nov 2014
Location: San Diego
Posts: 2,813
Likes: 73
Received 374 Likes on
238 Posts
Ive been working slowly. I got the elevation servo bracket fabbed and installed but haven't hooked the servo arm to the barrel carriage yet. I still have to make the recoil servo mount too.
Then I focused on the tranny cover, I felt the nick urethane one was too thin compared to my photos, also the bolt bar was too low after I made the tranny cover fit the metal mato hull so I had to file down the urethane cast on bolt bar and glue a Tamiya over it. Then I began building up the thickness with bondo and got some texture in it too. I might sand it a little more but I am super happy with the results.
Attached Thumbnails
Reply
Like
RichJohnson
View Public Profile
Send a private message to RichJohnson
Visit RichJohnson's homepage!
Find More Posts by RichJohnson
View iTrader Profile