RCU Forums - View Single Post - Finish a Sheeted Q500 Wing
Thread
:
Finish a Sheeted Q500 Wing
View Single Post
08-27-2016, 09:50 AM
#
5
sahartman21
Join Date: Nov 2007
Location: Fritch, TX
Posts: 2,060
Likes: 0
Received 0 Likes on 0 Posts
Finish a Sheeted Q500 Wing
The wing must be trimmed at the trailing edge.
Measure and mark a line so that the wing will have a 9 7/8" cord.
A razor saw was used to trim the width. I followed with a sanding block with 60 grit sand paper.
Attached Thumbnails
Reply
Like
sahartman21
View Public Profile
Send a private message to sahartman21
Find More Posts by sahartman21
View iTrader Profile