RCU Forums - View Single Post - Question about horizontal stab
Thread
:
Question about horizontal stab
View Single Post
11-25-2016, 02:57 PM
#
2
j.duncker
My Feedback: (
2
)
Join Date: Jun 2004
Location: Sailing in the Eastern Caribbean
Posts: 4,047
Likes: 0
Received 1 Like on
1 Post
There would be tiny roll and yaw inputs. If it is a trainer they can be ignored. Less than one click on the trims.
The pattern boys would get a bit uptight about it though.
Reply
Like
j.duncker
View Public Profile
Send a private message to j.duncker
Find More Posts by j.duncker
View iTrader Profile