Programming crow on DX18
Can anyone help with this? I'm using a 9030 receiver and flying the 30CC Ultra stick.
The channel assignments are as follows.
1 throttle
2 R ail
3 R elevator
4 rudder
5 L flap
6 L Ail (aux 1)
7 R flap (aux 2)
8 kill switch (aux 3)
9 L elevator (aux 4)
I would like to put this on switch B
position 0 - normal flaps and ailerons
position 1 - flaps and ailerons act as full ailerons
position 2 - crow - flaps down and ailerons up
Is this doable?
Red