RCU Forums - View Single Post - How to wire two BECs on a 2x 5S lipo setup
Thread: How to wire two BECs on a 2x 5S lipo setup
View Single Post
Old 10-20-2017, 09:38 PM
  #1  
Flyboywbl
 
Flyboywbl's Avatar
 
Join Date: Jul 2002
Location: Mahtomedi, MN
Posts: 318
Received 3 Likes on 3 Posts
Default How to wire two BECs on a 2x 5S lipo setup
Hello,

I decided to convert my BUSA 1/4 scale Nieuport 28 to electric and I was wondering how to wire up the BECs. It has two 5S lipos in series and there is no BEC on the ESC I want to have two RX’s. One for half the controls and one for the other half. I would also like to have two BEC’s. One to run each RX. I’m trying to figure out how to wire them so each lipo powers a different BEC. Is this possible or should I just run one off the mother bats in series and have a separate RX pack for the second RX?Any ideas?

Thanks!

-Matt
Flyboywbl is offline  
Reply Like