back at R/C again
Tl01 burned up the last brushless setup pretty quick- now I have a 4-pole 3000kv recktor brushless hopefully the higher torque will survive a bit longer.
BUT
Has anyone ever put a slipper clutch on a TL01??? I destroy spur gears every 4-5 runs I was looking at the ARP slipper clutch I think I can put it in place of the tamiya gears.
Maybe just cut the whole back chassis off and fiberglass the transmission area of another R/C?
" target="_blank">
by https://www.flickr.com/photos/149922130@N07/, on Flickr
" target="_blank">
by https://www.flickr.com/photos/149922130@N07/, on Flickr
Really tough truck now, metal gear high torque servo, every other moving part is aluminum/steel
So slipper clutch on a TL01
Not really a matter of money- but "can I find a way to do it?"
Some Ideas or insights from the experts on this page would be awesome!