Nice work! I look forward to more information about the build process. Thanks for posting.
__________________________________________________ __________________________________________________ ________
Got an email notification from RC Universe that you had sent me "6LQQKR2" a reply in regards to the Knight Twister Forum.
Your comment may have been intended for "stuntflyr". It is sometimes a little confusing as to whom an RCU reply is actually for.
That aside I have included a couple pictures of my scaled down 54" Knight Twister. It is powered by a RCGF 26 cc gas/oil engine and
weighs 14 lbs. finished with UltraKote, Spektrum Dx7 for guidance.
Note: the green on the bare bones picture is not a new type of hinge . It is green tape holding the movable surfaces in place prior
to hinging. Ha.
UltraKote finish
Twister finished but prior to hinging ailerons/rudder and elev.
Originally a 20 cc RCGF but changed to a 26 cc RCGF due to finished weight of the Twister.
Scratch fabricated cowl with hinged access door for adjusting carb needles.
.