RCU Forums - View Single Post - Putting the throttle on a switch on Futaba 10c
Thread: Putting the throttle on a switch on Futaba 10c
View Single Post
Old 04-17-2018, 02:39 PM
  #12  
mcjustis
 
Join Date: Jun 2006
Location: Columbus, IN
Posts: 127
Likes: 0
Received 0 Likes on 0 Posts
Default
Ran into a few issues. On mix 1 it won't let me put the SW as NULL. I tried it set to throttle stick .

on mix 2 it won't let me put the offset value as -100%. It won't go below zero.

mix 3 let me put in all parameters.

When i I check on the "servo" tab it doesn't show ch 3 as working.

Any ideas?
mcjustis is offline  
Reply Like