RCU Forums - View Single Post - Charlie Kellogg's TBM Avenger Build
Thread
:
Charlie Kellogg's TBM Avenger Build
View Single Post
10-26-2018, 11:56 AM
#
3434
redtail
My Feedback: (
15
)
Join Date: Oct 2002
Location: Alexandria, VA
Posts: 2,625
Likes: 2
Received 6 Likes on
6 Posts
Hey guys - Here is my setup. Hope to now fully adjust the tension on the rudder and the tailwheel cables. Larry - I have nyrod runs to both the rudder and the tailwheel, just sloppy and I did not notice it until clearly shown to me. Photos show the ends of the cable run, the circular servo arm used on the bottom of the rudder to move the rudder through cable. Been looking at it all to hard and far too long. Chic
Reply
Like
redtail
View Public Profile
Send a private message to redtail
Find More Posts by redtail
View iTrader Profile