Hello Mark,
I see you have a nice place picked for your new work bench and area. I like that is behind where most will walk by it, for just safety reasons, sharp edges and so on. Hey brother, your plane looks great and (the important part) fly's well for you! With all of that glue and depressed nose it is amazing (Phil and I were today just talking about this point) that Styrofoam is so forgiving and the planes still fly great even after the worst crashes. That's wonderful that you can get your son involved and he can be an Aviator like his Daddy!
Re the Corsair, that photo was just an example. The one I looked at is sold by Motion RC:
https://www.motionrc.com/products/fm...corsair-v2-pnp
or
https://www.motionrc.com/products/fm...-v3-1400mm-pnp But this is now discontinued. :-(
I am really strongly considering a Roban 800 size Scale Bell 222 Airwolf, please see the attached. The copter is sold ARF so I still would need the electronic. I see about $2,500 to get it up in the air. Please see link:
https://www.motionrc.com/products/ro...helicopter-arf
Now lets talk about my P-51D. I finished it today and she is ready to test fly perhaps tomorrow. It have been a labor I am here to tell you. The fuse was broken in half 90%, replaced, nose cone (not shown), props, rudder servo, one main landing gear retract, tail wheel retract, both of the main retracts the landing gear itself was good but the pin that connect the landing gear to the retracts were both bent and replaced. I just did a taxi up and down in front of my trailer and all seem well and I'll send that in an email, I don't want to post it here, to much work with YT and so on. I compressed it so it will fit an email.