Thanks.
My biggest hangup was the body, but now it is starting to come together. Too bad I have to wait till it warms up to work smoothing out the ripples, and spots where it doesn't 100% fit together properly as I have to do it out in the garage.
3D printer has really helped with this. If only I had this thing years ago, and all the stuff I could have come up with in my prime time for screwing around with RC's.
The rear though is going to be a bit of an issue though as I am going to have to cut it in pieces to print as my print bed is only 240x240, and scaling it is going to be fun as it was designed as a short bed for a 4 wheel version.