Danny:
Hello. Hope you can help me out. I just got a JR 6102 w/ R770S and 4 - 537 servos. I was going over the system working all servos. Here's where it gets bad...I've been on an old airtronics system with the 94102 servos (not the Z bends) and I was told by a local hobby shop that I could switch the poles of the airtronics servos and they will work with the new JR770. While doing this one of the poles touched the receiver pole, briefly, and I think that's all it took. I saw a little smoke and it smelled like I burned up something...UGH!!
I then waited a bit, plugged my 537 servos into the receiver and nothing...Did I screw the receiver up totally?!?? Please help.
[email protected]
Thanks,
Austin