Hi everyone, I have been flying for a while and only used analog servos. I recently purchased my first digital servos (HS-5645MG). I have a few question to those that can help.
1). What is "Servo Run In (Burn In)?
NEVER HEARD OF THIS
2). Why should it be done?
3). How is the "Run In" or "Burn In" accomplished?
4). Can I use my Futana 9C servo cycler mode to do the "Run In"?
5). How long to cycle them?
6). Should I do this on a regular basis?
Thanks for any advice...
DTB