HI there , i have just purchased a honeybee esky 2 3d copter. I have the same problem where it will just turn and i have no upwards lift. I have managed to lift off the ground very briefly and now i can not get it lifting. I tried to reverse the connection going into the receiver and it was blowing wind down and looking better. If i managed to get it lifting b4 i done this i take it that it was meant to be the way it was b4? I am a real newbie with helicopters and would appreciate any tips etc that i can get. Up 2 now have had no enjoyment in the heli i was looking forward to
(