RCU Forums - View Single Post - BUILDING your own VPP Setup
Thread
:
BUILDING your own VPP Setup
View Single Post
04-28-2005, 12:58 PM
#
24
wakle
Junior Member
Join Date: Jun 2004
Location: Los Osos, CA,
Posts: 19
Likes: 0
Received 0 Likes on 0 Posts
RE: BUILDING your own VPP Setup
Tnanks Levi,
I ordered the tail rotor parts and tubing. Where do we get the blades?
I had used roll pins for the .125 D AXI, but your solution is more elegant and also works on my 3 mm Hackers.
Wade
Reply
Like
wakle
View Public Profile
Send a private message to wakle
Find More Posts by wakle
View iTrader Profile