RE: T-maxx axle carriers and half shafts on a fun factor
Over the past week or so I have been working pretty much constantly on the Savage a-arms to get them working properly. I have had them bolted up to the bulkheads and even had the Savage wheels on it. However, to get the arms to articulate fully meant cutting away a fairly large portion of the arm. Then even more needed to be removed as the diffs where not in line with the hub, this was a nightmare on the front due to the steering complicating things further. In the end I realised that I was weakening the arm to a degree where it would not be a workable option and certainly not an improvement on the CEN arms. So sadly I am back to the drawing board. Thinking down the line of buggy arms with the Proline 23mm spacers. Still, got some spare hubs, bearings and drivecups for the Savage out of it!!