RCU Forums - View Single Post - Cutting slots in plywood
Thread
:
Cutting slots in plywood
View Single Post
11-17-2005, 09:18 PM
#
13
r degen
Join Date: Dec 2001
Location: Spencerville, OH
Posts: 165
Likes: 3
Received 0 Likes on 0 Posts
RE: Cutting slots in plywood
I would use a router table with a fence I think you can get high speed steel bits from sears or use an 1/8 inch end mill. Randy
Reply
Like
r degen
View Public Profile
Send a private message to r degen
Find More Posts by r degen
View iTrader Profile
RE: Cutting slots in plywood