RCU Forums - View Single Post - 2 Klunk/Pump Setup
Thread: 2 Klunk/Pump Setup
View Single Post
Old 12-02-2005, 12:47 AM
  #14  
Oldbob
 
Join Date: Jun 2005
Location: georgetown, TX
Posts: 637
Likes: 0
Received 0 Likes on 0 Posts
Default RE: 2 Klunk/Pump Setup
Has anyone noticed high fuel consumption when using the uniflow system on an RC engine? From my experience fuel from the tank backs-up into the muffler when the engine goes from high RPM to idle. This fuel is not burned in the engine but just goes out the muffler. Has anyone noticed this?

Bob P.
Oldbob is offline  
Reply Like