RCU Forums - View Single Post - Servo End Point Adjustment
Thread
:
Servo End Point Adjustment
View Single Post
03-15-2006, 07:01 AM
#
2
BillS
Senior Member
Join Date: Sep 2004
Location: Greensboro, NC
Posts: 3,312
Likes: 0
Received 1 Like on
1 Post
RE: Servo End Point Adjustment
I think you get greater mechanical leverage with higher EPA at a very slight speed penalty. When using dual rates I prefer the low rate setting to be under 100%.
An EPA under 50% is very taxing on the servos.
Bill
Reply
Like
BillS
View Public Profile
Send a private message to BillS
Find More Posts by BillS
View iTrader Profile