RCU Forums - View Single Post - Setting up a choke servo
View Single Post
Old 12-30-2002, 03:28 PM
  #1  
ml3456
 
Join Date: Oct 2002
Location: Darien, IL
Posts: 626
Likes: 0
Received 0 Likes on 0 Posts
Default Setting up a choke servo

I want to use a choke servo on my BME 50 for both starting and shut down. I was going to set it up for operation from one of the knobs, but I want to limit it to only operate when the throttle lever is all the way down and the trim set at 50%.

Is there a way to program this so it only works in the lower percentage throw of the throttle stick? This would be the secondary safety shutoff if my throttle servo malfunctions.

thanks again

mark