RCU Forums - View Single Post - carving aluminum spinners
Thread
:
carving aluminum spinners
View Single Post
01-21-2003, 04:16 PM
#
3
Goinstraightup
Senior Member
My Feedback: (
26
)
Join Date: Dec 2002
Location: Baraboo , WI
Posts: 2,307
Likes: 0
Received 0 Likes on 0 Posts
carving aluminum spinners
Yep, that's the best. Start with a small router bit like 1/8 dia. Try to not let it get away from you. Then go to 1/4 dia. drum. If you have a really big prop, the 1/2 inch dia. drum will make it look nice.
Reply
Like
Goinstraightup
View Public Profile
Send a private message to Goinstraightup
Find More Posts by Goinstraightup
View iTrader Profile