RE: Engine break in procedure?
I have a FH as well. I just mixed the my oil/gas ratio to 32 to 1 and run it. I dondn't run it ver hard the first tank but ran at varying speeds. After that I actually had ti richen my lowend from the factory setting to take away some of my lowend bogging. I leaned the highend just so it it cleaned itself out good.
I did put a pipe on now after two tankfuls and changed my settings a little. I actually had to lean the highend end out some to get it to run good and again had to richen my lowend a tad to get it to not bog. It runs like a champ.