RCU Forums - View Single Post - Speed props – a difficult task
Thread: Speed props – a difficult task
View Single Post
Old 08-13-2007, 03:50 PM
  #14  
Cyclic Hardover
Senior Member
My Feedback: (3)
 
Cyclic Hardover's Avatar
 
Join Date: May 2002
Location: New Mexico,
Posts: 7,296
Likes: 0
Received 1 Like on 1 Post
Default RE: Speed props – a difficult task
ORIGINAL: daven

Rather than minor tip clipping, try removing a 1/16 - 1/8" off the TE of the blade (narrowing the blade).

Never heard this approach. Does it work well? How are you trimmng this?. Sounds like ths would be best on the smaller Q500 stuff?
Cyclic Hardover is offline  
Reply Like