RCU Forums - View Single Post - KMP FlyCat 90
Thread
:
KMP FlyCat 90
View Single Post
11-12-2008, 06:25 AM
#
14
BaldEagel
Join Date: Oct 2005
Location: Kent, UNITED KINGDOM
Posts: 9,669
Likes: 2
Received 5 Likes on
5 Posts
RE: KMP FlyCat 90
After lots of sanding to the top of the fin I managed to get the aligniment somewhere close, the stab is made of balsa and the fixings into the stab are not good enough IMO to take the loads this will be subjected too, I am therefore thinking of permanently attaching the stab to the fin, may just make the fixings wider in the stab with a piece of carbon as reinforcement.
Mike
Attached Thumbnails
Reply
Like
BaldEagel
View Public Profile
Send a private message to BaldEagel
Find More Posts by BaldEagel
View iTrader Profile