View Single Post
Old 12-05-2008, 01:54 PM
  #36  
hemi
 
Join Date: May 2002
Location: Washington, MI
Posts: 218
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Composite ARF Mig29

Van
I'm working on the inlets and have enlarged the nacelle opening on the top to allow the inlets to slide into place, my question is this when you epozy the inlets in place how far forward should they be? One picture in the manual shows some excess sticking out front that gets squared off later. But one of the pictures in this post lloks like the inlet is slightly back from the leading edge of the nacelle. My inlets have a rather nasty seam that I'll have to deal with to get a good fit. Thanks for the email on the Mig, you got me started again on this great project.

Best regards
hemi is offline  
Reply With Quote