RCU Forums - View Single Post - Reason for not upgrading to 2.4
View Single Post
Old 04-27-2009, 06:01 PM
  #18  
onewasp
Senior Member
 
Join Date: Dec 2002
Location: USA
Posts: 2,035
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Reason for not upgrading to 2.4

tankertoad,

YOU are quite misinformed !!!!!

Spektrum reboots faster than you can click a stop watch.
It was a problem for a very few (those who didn't size batteries properly or who don't check their systems prior to flight, though I have only read of it. I have NEVER seen it nor have we had it occur locally. We still have generation one {firmware}Spektrums flying daily.

I fly a full load of high end digitals and have done so since they came out!
NO PROBLEM. We have a 35% Bipe flying DX7 and all digitals on 4.8Volts without problems (I happen to use A123)

Seriously, I feel that the problem is with the operator in your case____simply the way it computes
You have been at this 4 years according to your profile so some reading is in order for you.
I don't wish to seem overly harsh to someone so new to the hobby, but you simply have neither the credentials nor the experience to make a radio system judgment.

Look up XJet and go to his site on 2.4GHz and study it. He is an RF Engineer who is also an RC'r That is an unusual combination!

I will post back with the exact site so that you can get up to date. Even then you will need to keep reading as you can't define SS in a few pages. It is unique. It is the state of the art in RC.


Edit addition: Here is the link I promised: be certain to click forward at the end of each page.
http://www.rcmodelreviews.com/spreadspectrum01.shtml

Here also is a link on the Quick Connect Firmware update (note the date. This is over two months AFTER it was first available:http://www.rcuniverse.com/forum/m_70...tm.htm#7080754

Yet another site: http://www.rcgroups.com/forums/showthread.php?t=1038506