RCU Forums - View Single Post - Flat plate wing thing
Thread
:
Flat plate wing thing
View Single Post
08-15-2009, 05:41 PM
#
1
Mike Connor
Senior Member
My Feedback: (
5
)
Join Date: Jan 2002
Location: Tulsa, OK
Posts: 2,025
Likes: 0
Received 0 Likes on 0 Posts
Flat plate wing thing
I was working on a high aspect ratio flying wing with electric in mind but the short cord was giving me fits fitting the gear into a narrow area. After looking at pictures of a X-48B I came up with an idea of half delta and half flying wing. This would allow me to do every thing I wanted to do and I think it looks kind of cool.
It is a flat plate wing with a thickness of 3/8". That gives it a 2.2% wing thickness at the root next to the equipment compartment and 5.2% at the tip. The two spars are 1/4" continuous basswood with balsa ribs. I cut out the 1/16" balsa wing skins and traced the plans onto them. Then I just glued the wood onto the wing skin on a flat surface.
Attached Thumbnails
Reply
Like
Mike Connor
View Public Profile
Send a private message to Mike Connor
Find More Posts by Mike Connor
View iTrader Profile