RCU Forums - View Single Post - BUSHWACKER, MARK'S MODELS, 1970s

05-09-2010, 04:50 AM

#9

optech

My Feedback: (9)

Join Date: Jan 2002

Location: Copperas Cove, Tx.

Posts: 552

Likes: 0

Received 0 Likes on 0 Posts

RE: BUSHWACKER, MARK'S MODELS, 1970s

Quote:

ORIGINAL: jskrebs

I do like the idea of getting the kit scanned or duplicated so it could be laser cut. think the rib sheets could be scanned? Personally I think this kit should be re kitted. Would have to be laser cut, nobody would make steel rule dies anymore.

I am pretty sure it would cost more than $125 though. I was looking at a modern kitted Curare and it's well over $200. Will build that one day as well, also Electric.

Jeff

Check out this thread. It is very possible to get parts from die-cut sheets without removing the parts;

http://www.rcuniverse.com/forum/m_1296519/tm.htm

I know of a couple of guys that have sent complete kits to Lazerworks and they were able to reproduce enough parts to build from. Check out his prices... VERY REASONABLE. I've got a few kits I'm planning to send.

I'd love to build one of these. I just picked up an Enya .19X that would be perfect for this plane.

Mike

Reply Like