eclipse 7 throttle stick
I have just setup the Eclipse 7 idle up 2 setting, which on the Tx is ST2 switch setting.
100 75 45 75 100 settings 1 2 3 4 5.
Now it works ok but if I give the stick a full up or down (full end of the stick) the throttle goes to 0 if I let go it goes to 100.
I have tried end point adjustments, reducing the amount of full throttle on each end etc. But it still happens. Lucky I wasn't flying.
Is there something I have missed?
This doesn't happen with the other flight modes, although I haven't got a -9 0 9 setup on them.
regards
rich