Help, my CCD camera connector broke!
02-08-2004, 11:25 PM
#1
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Gainesville,
FL
Posts: 423
Likes: 0
Received 0 Likes
on
0 Posts
Help, my CCD camera connector broke!
Great! These CCD cameras from Supercircuits have 18 ga shielded cable
all the way down to the tiny white connector that connects to the board of the camera.
Theres its about 26 ga!!
With my tilt going all the time it broke and its too small for me to solder and
Supercircuits sells replacement cables but not for this camera (yet) Its the PC195XS.
If anyone has had experience with this, please help!
Thanks in advance,
all the way down to the tiny white connector that connects to the board of the camera.
Theres its about 26 ga!!
With my tilt going all the time it broke and its too small for me to solder and
Supercircuits sells replacement cables but not for this camera (yet) Its the PC195XS.
If anyone has had experience with this, please help!
Thanks in advance,
02-09-2004, 09:41 AM
#2
Senior Member
Join Date: Dec 2002
Location: Appleton, WI
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
RE: Help, my CCD camera connector broke!
Solder wires onto the board, surround the solder points with E6000, make a small pigtail with a more durable connector.
Robert Lehman
Robert Lehman
02-09-2004, 06:12 PM
#3
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Gainesville,
FL
Posts: 423
Likes: 0
Received 0 Likes
on
0 Posts
RE: Help, my CCD camera connector broke!
I already started soldering last night but it got late, the holes got smaller, you know!
Maybe Ill take a picture and send to them after Im done and say, "See, THIS is a connection!"
But these cameras are usually set up in a fixed location and left alone,
not tilting and swiveling around!
Thanks!!
Maybe Ill take a picture and send to them after Im done and say, "See, THIS is a connection!"
But these cameras are usually set up in a fixed location and left alone,
not tilting and swiveling around!
Thanks!!
