Trouble with SD-10G mixing
#1
Thread Starter
My Feedback: (8)
Trouble with SD-10G mixing
Mixing functions seem to be working intermittently. Rudder to elevator works the best, but can't seem to get throttle->rudder or rudder->aileron to work at all. When trying to setup throttle->rudder, the rudder will sometimes twitch a little while I increase/decrease the percentages to +/- 100% with throttle stick all the way up.
All mixes right now are under Flight Mode N, and of course the flight mode stick is in the N position.
Setup is electric with CC ICE HV80 and fixed end points.
Not sure what's going on...
All mixes right now are under Flight Mode N, and of course the flight mode stick is in the N position.
Setup is electric with CC ICE HV80 and fixed end points.
Not sure what's going on...
#3
Thread Starter
My Feedback: (8)
RE: Trouble with SD-10G mixing
How do I do this: I would like to have stick switch (throttle) control throttle->elevator mix, such that when I reduce the stick to 0% some down elevator kicks in for down lines. I'd like no mixing to occur at any throttle setting except 0%.
Thanks!
Thanks!
#5
Join Date: Mar 2005
Location: Orange County, CA
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
RE: Trouble with SD-10G mixing
Mixes can also just be "on" in the stick switch menu. So, if you don't want to have the ability to turn the mix on/off, just cycle all the way through all of the switch choices until you get to "on"
Also, com and sep mean common to all flight modes, or separate means will be set independently for each flight mode.
One note, if you're not using flight modes, make sure you turn off their switch assignments in the switch menu!
Mike
Also, com and sep mean common to all flight modes, or separate means will be set independently for each flight mode.
One note, if you're not using flight modes, make sure you turn off their switch assignments in the switch menu!
Mike