Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Results 1 to 2 of 2

  1. #1

    Join Date
    Jan 2002
    Location
    Auckland, NEW ZEALAND
    Posts
    241
    Gallery
    My Gallery
    Models
    My Models
    Ratings
    My Feedback

    Airtronics RDS 8000 Receiver Binding

    Hi

    I have a Receiver that has been previously PAIRED to a MODE 1 Airtronics Radio, and I wish to Bind to my Mode 2 but having difficulties, do I have to position switched in any particular sequence?

    I have F 2 facing away throttle LOW turn on Radio Led Lights Up then I Hold down Bind Button on receiver turn it on Flashes slowly then press Radio nothing happens, now starting to loose my Hair so may have to buy a toupee, any suggestions but not on the Toupee?
    Maybe I am missing something


    Thanks

    Ray

  2. #2

    Join Date
    Aug 2009
    Location
    St. Cloud, FL
    Posts
    461
    Gallery
    My Gallery
    Models
    My Models
    Ratings
    My Feedback
    I am not sure if this will help, but this is right out of the RDS8000 manual!

    Prior to programming your RDS8000 transmitter, you should Bind your receiver to your transmitter so your receiver will only receive
    commands from your transmitter.
    To bind your receiver to your transmitter, move your throttle stick to the low position and turn on your transmitter power switch. The
    Blue BIND LED on the left side of the panel will illuminate. Connect your onboard battery with a switch harness to connect the power
    to your receiver. While holding down the little BIND key on the receiver, turn on the receiver power switch. The BIND LED will flash
    slowly. When it flashes slowly let go of the receiver BIND key. While the BIND LED on the receiver is flashing slowly, momentarily
    press the BIND key on the transmitter and release it. The BIND LED on the receiver will start to flash rapidly and then will light
    solidly indicating that the binding was successful. Note that unless the BIND key on the transmitter is pressed within 10 seconds
    while the BIND LED on the receiver is flashing, the BIND LED on the receiver will automatically time out and stop flashing. If this
    occurs, repeat the above steps.
    Once you have performed the binding process you are ready to program your transmitter

    Hope this helps!

    Craig.
    Ultra Sport Brotherhood #10
    Revver Bro #263
    Tiger Club #26


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
All times are GMT -6. The time now is 09:59 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.