Airtronics RDS 8000 Receiver Binding
#1
Senior Member
Thread Starter
Join Date: Jan 2002
Location: Auckland, NEW ZEALAND
Posts: 241
Likes: 0
Received 0 Likes
on
0 Posts
Airtronics RDS 8000 Receiver Binding
Hi
I have a Receiver that has been previously PAIRED to a MODE 1 Airtronics Radio, and I wish to Bind to my Mode 2 but having difficulties, do I have to position switched in any particular sequence?
I have F 2 facing away throttle LOW turn on Radio Led Lights Up then I Hold down Bind Button on receiver turn it on Flashes slowly then press Radio nothing happens, now starting to loose my Hair so may have to buy a toupee, any suggestions but not on the Toupee?
Maybe I am missing something
Thanks
Ray
I have a Receiver that has been previously PAIRED to a MODE 1 Airtronics Radio, and I wish to Bind to my Mode 2 but having difficulties, do I have to position switched in any particular sequence?
I have F 2 facing away throttle LOW turn on Radio Led Lights Up then I Hold down Bind Button on receiver turn it on Flashes slowly then press Radio nothing happens, now starting to loose my Hair so may have to buy a toupee, any suggestions but not on the Toupee?
Maybe I am missing something
Thanks
Ray
#2
Senior Member
My Feedback: (6)
Join Date: Aug 2009
Location: St. Cloud, FL
Posts: 556
Likes: 0
Received 0 Likes
on
0 Posts
I am not sure if this will help, but this is right out of the RDS8000 manual!
Prior to programming your RDS8000 transmitter, you should Bind your receiver to your transmitter so your receiver will only receive
commands from your transmitter.
To bind your receiver to your transmitter, move your throttle stick to the low position and turn on your transmitter power switch. The
Blue BIND LED on the left side of the panel will illuminate. Connect your onboard battery with a switch harness to connect the power
to your receiver. While holding down the little BIND key on the receiver, turn on the receiver power switch. The BIND LED will flash
slowly. When it flashes slowly let go of the receiver BIND key. While the BIND LED on the receiver is flashing slowly, momentarily
press the BIND key on the transmitter and release it. The BIND LED on the receiver will start to flash rapidly and then will light
solidly indicating that the binding was successful. Note that unless the BIND key on the transmitter is pressed within 10 seconds
while the BIND LED on the receiver is flashing, the BIND LED on the receiver will automatically time out and stop flashing. If this
occurs, repeat the above steps.
Once you have performed the binding process you are ready to program your transmitter
Hope this helps!
Craig.
Prior to programming your RDS8000 transmitter, you should Bind your receiver to your transmitter so your receiver will only receive
commands from your transmitter.
To bind your receiver to your transmitter, move your throttle stick to the low position and turn on your transmitter power switch. The
Blue BIND LED on the left side of the panel will illuminate. Connect your onboard battery with a switch harness to connect the power
to your receiver. While holding down the little BIND key on the receiver, turn on the receiver power switch. The BIND LED will flash
slowly. When it flashes slowly let go of the receiver BIND key. While the BIND LED on the receiver is flashing slowly, momentarily
press the BIND key on the transmitter and release it. The BIND LED on the receiver will start to flash rapidly and then will light
solidly indicating that the binding was successful. Note that unless the BIND key on the transmitter is pressed within 10 seconds
while the BIND LED on the receiver is flashing, the BIND LED on the receiver will automatically time out and stop flashing. If this
occurs, repeat the above steps.
Once you have performed the binding process you are ready to program your transmitter
Hope this helps!
Craig.