Airtronics (Sanwa) RX-61H RX running HV
#1
Junior Member
Thread Starter
Join Date: Apr 2007
Location: Auckland, NEW ZEALAND
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Airtronics (Sanwa) RX-61H RX running HV
Hi,
I'm wanting to use HV servos in an IOM yacht and was wondering if anyone has run a RX-61H RX at 8.4v. Manual says 4.8-6.0v but I really would like to run 2 cell lipos thru it. Is it a goer or am I toast ? At $65 it is a bit expensive for an 'Oh well try it and see !!!'
Thanks.....
I'm wanting to use HV servos in an IOM yacht and was wondering if anyone has run a RX-61H RX at 8.4v. Manual says 4.8-6.0v but I really would like to run 2 cell lipos thru it. Is it a goer or am I toast ? At $65 it is a bit expensive for an 'Oh well try it and see !!!'
Thanks.....
#3
Member
Join Date: Mar 2007
Location: Fairfield,
CA
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
RE: Airtronics (Sanwa) RX-61H RX running HV
The RX61H, part number 92064, is a Park Flyer receiver with a range of approximately 1200 feet in the air. The RX61H is a FHSS-3 type receiver...... All FHSS-3 receivers are OK up to a 2S Li-Po. Do not exceed two cells!
AIRTRONICS TECHNICAL SUPPORT
800-262-1178
AIRTRONICS TECHNICAL SUPPORT
800-262-1178
#4
Join Date: Dec 2003
Location: Osprey,
FL
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
RE: Airtronics (Sanwa) RX-61H RX running HV
I am replying to your comments about the work that is being done at SANWA to fix the Airtronics retract problem using the Dynam retract. Have an RD8000 and I cant operate the retracts. You mentioned that SANWA was working on a device that work hook up to the Airtronics receiver and correct the problem. Have you any additional information? I would like to have my AT6 retracts working. Please tell me the contact at SANWA so I can follow up.