reciever antenna
I screwed up and crashed. The crash took off half of one antenna and maybe 1/8 in on the other. Its a 2.4 reciever. Trash, right?
|
RE: reciever antenna
ORIGINAL: stevenmax50 I screwed up and crashed. The crash took off half of one antenna and maybe 1/8 in on the other. Its a 2.4 reciever. Trash, right? If you had major crash you might want to send the receiver in to Airtronics to be checked out. If the receiver is OK they will replace the antennas. My experience has been very good with the service department. |
RE: reciever antenna
What is the value of he plane you are installing it it? Foamie, small electric, get repaired and try it out. Giant scale gasser? Circular file it and get new one.. Risk vs reward.<div>
</div><div>Whit</div> |
RE: reciever antenna
The receiver coaxial antenna for most of our 2.4 GHz aircraft receivers is part number 490027. You can order it from the hobbypeople.net web site by typing 490027 in the search box. Check your receiver and see if the antennas have a small gold connector on them which plugs into the receiver circuit board. You can use a very small screw driver to lift the gold connector off of the circuit board. The new antennas can then be plugged in to the board. If the receiver is damaged, you need to return it to Airtronics for repair/replacement.
AIRTRONICS TECHNICAL SUPPORT 800-262-1178 |
Have the receiver checked by Airtronics. They will replace the antenna and make sure the receiver is working properly. Cheap insurance!!! And at less cost than buying a new receiver
|
Will it damage the receiver????
Originally Posted by stevenmax50
(Post 11567752)
I screwed up and crashed. The crash took off half of one antenna and maybe 1/8 in on the other. Its a 2.4 reciever. Trash, right?
So in the meantime can I still fly if one antenna is unharmed and the other has been slightly shortened right up to the gray insulation? From that, I'm guessing the coax shield MAY be touching the inner antenna wire. Problem, or not? Will something fry if one of the two antennas is messed up on the end? Thanks for any experiences, advice, or comments. Phil |
All times are GMT -8. The time now is 04:29 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.