A123 Dual switch set-up question
05-24-2014, 03:05 AM
#1
Thread Starter
My Feedback: (212)
Join Date: Feb 2004
Location: MOUNT OLIVE,
NC
Posts: 615
Likes: 0
Received 0 Likes
on
0 Posts
A123 Dual switch set-up question
One Duralite 2S2P 4600ma A123 battery with two power leads one each going to two seperate heavy duty switches. The yellow balance tap/charge tap will have it's own port(this is what I'll use for charging). Each switch will have a lead connected directly into the Futaba 6008 Receiver. For a 50cc plane with 7 digital servos, is this an acceptable set-up? Thanks for the help.
05-25-2014, 01:01 PM
#2
I run one A123 2300mah battery with two leads through two switches for my 50cc aerobat. This gives me 2 inputs to the receiver. I get 4 flights and then recharge. Each flight uses about 250ma according to my cellpro 4s. Your proposed setup should be more than adequate.
