NIMH battery repair
#1
Member
Thread Starter
Join Date: Dec 2010
Location: Forest Grove, OR
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
NIMH battery repair
So my battery broke. Well a wire disconnected. Now I have experience soldering but have never done a battery. It's a dura trax onyx battery
So what I'm asking is can I just clean up the old solder point and 're solder back together? Or will this cause problems? If ya know how to repair this please let me know?
So what I'm asking is can I just clean up the old solder point and 're solder back together? Or will this cause problems? If ya know how to repair this please let me know?
#2
Just make sure both the battery and the cable are tinned well; with a hot enough iron (I would recommended at least a 60w iron), you should be good to go. Oh, and try not to short circuit the wires. That big, loud spark is always a wake me up.
Last edited by RustyUs; 04-02-2015 at 03:17 PM.